Energies, Vol. 19, Pages 1343: An Assessment of the Non-Repeatability of a Diesel Engine Cycle-by-Cycle Operation Under Variable Load and Speed Conditions
Energies doi: 10.3390/en19051343
Authors:
Dariusz Szpica
Kamil Kluczyński
The non-repeatability of the internal combustion engine’s cycle-by-cycle (CCN-R) operation directly affects pollutant emissions, fuel consumption, and energy efficiency. Reducing this non-repeatability is an important part of efforts to improve the environmental performance of power units. Cycle variability analysis allows the identification of engine operating areas that promote unstable combustion and increased emissions of harmful exhaust components. The aim of the study was to quantitatively assess the cycle-to-cycle non-repeatability COV of selected operating parameters of the Perkins 1104D-E44TA diesel engine. The analyses covered the maximum cylinder pressure (pmax), the mean indicated pressure (IMEP), and the crankshaft rotation angle corresponding to the occurrence of maximum pressure (α). The measurements were carried out on an engine dynamometer at 25 operating points, covering speeds 1000–2200 r./min and load torques 200–400 N × m, recording 500 consecutive operating cycles at each point. The results showed that the most stable engine operation occurred at medium rotational speeds and moderate loads, where COVpmax values did not exceed 0.5% and COVIMEP values were lower than 1.0%. Increased pmax non-repeatability (up to 2.10%) and very high α angle variability (up to 100–140%) were observed at high rotational speeds and high loads. Only in the case of COVIMEP was a significant reduction in repeatability observed compared to idling. The results obtained from cycle-by-cycle non-repeatability analyses can ultimately, after being supplemented with exhaust gas composition testing, be used as tools to support engine control optimization in order to reduce pollutant emissions and improve combustion efficiency.