Energies, Vol. 19, Pages 1465: Research on Mechanism-Based Modeling and Simulation of Heavy-Duty Industrial Gas Turbines
Energies doi: 10.3390/en19061465
Authors:
Bingzhou Ma
Haoran An
Hongyi Chen
Feng Lu
Jinquan Huang
Qiuhong Li
This study investigates mechanism-based modeling and simulation of a single-shaft heavy-duty industrial gas turbine. Taking the PG9171E gas turbine as the case study, component-level steady-state and dynamic models are developed. The steady-state model is established using the constant mass flow (CMF) method. For dynamic modeling, both the CMF approach and the inter-component volume (ICV) approach are implemented to enable a comparative assessment of the two methods. On the basis of the steady-state model, an improved Dung Beetle Optimization (DBO) algorithm is proposed to perform model correction using measured operational data from the gas turbine. After model correction, the maximum relative error between the simulated results and the measured operating data is reduced to 1.01 × 10−5%. Following high-accuracy model correction, sensitivity analysis and a comparative dynamic study are conducted for the two dynamic modeling approaches. The results indicate that the most influential sensitivity parameter is the rotor rotational inertia, followed by the virtual volume of the combustor. Moreover, the primary discrepancy between the ICV and CMF approaches arises from differences in the operating trajectories on component characteristic maps. The ICV-based model exhibits a pronounced response lag; however, it requires less computational time than the CMF-based model, making it more suitable for rapid engineering simulation and practical applications.